2008-2017 Mitsubishi Lancer Duraflex Ralliart Look Front Bumper – 1 Piece

$613.00

2008-2017 Mitsubishi Lancer Duraflex Ralliart Look Front Bumper – 1 Piece… Fitment

This is classified as an oversize item. Good news however... The shipping is included in the price!
SKU: 117488 Categories: ,

Description

2008-2017 Mitsubishi Lancer Duraflex Ralliart Look Front Bumper – 1 Piece

All  body kits, ground effects, and products produced by Extreme Dimensions qualify as aftermarket modification products intended for off-road and show use. Because of the extreme design, Extreme Dimensions cannot be liable for damage caused by road use of its products. Further, products may need prep work such as sanding, shaving, filling gaps, and/or other modifications. It is highly recommended that you use professionally experienced collision repair and body part specialists to install Extreme Dimensions products. Some parts may not be street legal or qualify for use on public streets.

Limited Warranty

Extreme Dimensions, Inc. warrants products from manufacturing defects in workmanship and materials when installed properly and used for its intended use. The warranty is non-transferable. Products covered by this warranty and discovered with reasonable assessment to be defective in materials or workmanship will be replaced at the request of the customer.

Hood and Trunk Guarantee

Extreme Dimensions will fully replace your BMW hood for the following reasons:

  •  Hood does not clear stock engine
  •  There are gaps between the hood and the fenders and more than 1/2″ wide on each side
  •  Hood levels out more than 3/8″ higher or lower than the fenders
  •  Latch length incorrect compared to the stock latch, preventing the hood from latching after adjusting

 

Extreme Dimensions, Inc. will not guarantee fitment on vehicles previously involved in accidents and/or have had body damage or modification. Hood pins will be required on all hoods.

Trunks are warrantied for the following reasons:

  • Gaps between the trunk and the rear fenders are more than 1/2″ wide on each side
  •  Trunk levels more than 3/8″ higher or lower than the rear fenders

Additional information

Weight 15 lbs
By Type

Kit Material

Ship Category